How Do I Fix An Overwound Clock

Untitled

Untitled

48 Years Repairing Of Antique Pendulum Clocks Mackey S Antique

48 Years Repairing Of Antique Pendulum Clocks Mackey S Antique

Contact Express Watch Clock Repair

Contact Express Watch Clock Repair

I Have A Limited Edition Kelohna Clock Salem Clock Co My Grandson

I Have A Limited Edition Kelohna Clock Salem Clock Co My Grandson

Lux Wind Up Clock Etsy

Lux Wind Up Clock Etsy

How To Fix An Overwound Wind Up Toy

How To Fix An Overwound Wind Up Toy

Turn the key slowly and just a half turn at a time.

How do i fix an overwound clock. The buildup of residue causes them to become sticky which creates the effect of a clock being over wound and the clock stops working. Essentially from the users perspective it is. Rub the alcohol soaked brush over the wheels and pinions. This can create larger problems because it eventually affects the other parts of the clock.

Some clocks will run faster if they are wound too tightly in the first 24 hours after youve tightened the mainspring. When you do wind your clock just make sure you have a tight fitting key and that it is inserted all the way. Answered by a verified clock repair expert we use cookies to give you the best possible experience on our website. Remove the screws that hold the movement housing in place.

Something is preventing it from running. Open the movement case and under a bright lamp light and with the aid. How to unwind an overwound clock. May i use a car analogy.

If you fill your car with gas but you dont drive it its not going to use any more fuel and the gas tank will remain full. The more you take the time to wind the more wear you are putting your clock through. Over time mainsprings in a clock become dirty. This gives the appearance of the clock being wound too tight.

2dip a 12mm paintbrush in rubbing alcohol and slowly brush it over the pinion teeth and pivots. Remove the back of the clock with a small screwdriver like those designed for eyeglass repairs. The old urgos spring drive clocks have an arbor that has a small groove cut in it for assembly convenience that will snap if you force it. If your timepiece has a tiny pendulum you may need to wind it more often.

Wind it up until it stops. Do not try to force it to wind any further. Your clock is fully wound up but it is not running. Unfasten the clock hands by holding the minute hand and turning the nut to the left.

How do i get an overwound mantle clock to run again. How to comfortably wind.

-->